ماہر رہنما

عام آبدوز پمپ کے مسائل اور حل

کم پانی، ٹرپنگ، شور، زیادہ گرم ہونا اور پانی نہیں — عام مسائل کی شناخت اور حل کریں۔

6 منٹ پڑھنا کنگویل
عام آبدوز پمپ کے مسائل اور حل

زیادہ تر آبدوز پمپ کے مسائل غلط تنصیب، پانی کی سطح میں تبدیلی، بجلی کی خرابیوں یا پمپ کے غلط انتخاب سے آتے ہیں۔ خدمت کے لیے کال کرنے سے پہلے عام علامات اور عملی حل اس گائیڈ میں ہیں۔

01

پمپ شروع نہیں ہوتا ہے۔

Possible causes:

  • No power or tripped MCB — check supply and control panel
  • Low voltage — use stabilizer; motors need rated voltage
  • Cable fault or loose joint — inspect cable from panel to pump
  • Dry run protection activated — verify water level in borewell

Solution: Restore power, fix cable joints, ensure adequate water level, then restart. If motor hums but does not spin, contact authorized service.

02

پمپ چل رہا ہے لیکن پانی نہیں ہے۔

Possible causes:

  • Water level dropped below pump intake
  • NRV (non-return valve) stuck or leaking
  • Pipeline leak or air lock in delivery pipe
  • Impeller choked with sand or debris
  • Wrong pump depth setting

Solution: Check water level, inspect NRV and pipes, clean strainer, verify pump is submerged correctly. A complete system inspection restores flow.

03

کم دباؤ یا کم بہاؤ

Possible causes:

  • Partially blocked strainer or pipeline
  • Increased pipe friction from undersized pipe
  • Worn impeller or declining water table
  • Pump operating below rated voltage

Solution: Clean strainer every 3–6 months, verify pipe diameter matches pump capacity, test voltage at panel, and reassess HP if water table has fallen significantly.

04

بار بار ٹرپنگ یا زیادہ بوجھ

Possible causes:

  • Overload relay set too low
  • Single phase failure on three phase supply
  • Mechanical binding or sand ingress
  • Pump oversized for borewell yield (cycling)

Solution: Check all three phases, reset overload correctly, inspect for sand damage, and confirm pump HP matches borewell capacity with your dealer.

05

غیر معمولی شور یا کمپن

Possible causes:

  • Pump hitting borewell wall during installation
  • Loose mounting or worn bearings
  • Cavitation from insufficient submergence
  • Electrical imbalance

Solution: Ensure central alignment in borewell, maintain minimum submergence as per guidelines, schedule dealer inspection for bearing or mechanical wear.

06

کنگویل سروس کو کب کال کرنا ہے۔

Contact your nearest authorized کنگویل dealer if:

  • Motor burns repeatedly after repair attempts
  • Water flow suddenly stops after years of normal use
  • Warranty repair is needed
  • Pump needs pulling and inspection from borewell

Keep GST invoice and warranty card ready for faster support.

📞ابھی کال کریں 💬واٹس ایپ 📋قیمت حاصل کریں